For problems with Gamebuino itself, NOT your project
by finalzero » Sun Aug 03, 2014 11:53 am
hello there,
good, that I would disassemble my console screen,
but I fear the botched or broken ...
you could not put a picture behind the screen when it is disassembled to its location?
thank you to you.
-
finalzero
-
- Posts: 51
- Joined: Fri Jul 18, 2014 12:12 pm
- Location: France Montpellier
by 94k » Sun Aug 03, 2014 1:49 pm
I'm not sure I understand, but the screen should have exposed metal at the back, those go on the rubber on the board, knowing this it's hard to put it back together wrong. As for disassembling it without breaking it, you should be able to see 4 clips where the screen is clipped in at the back of the board, use your fingernails or a flat screwdriver to open them, but be carefull they're in there pretty tight. They don't carry any signal, so you shouldn't worry too much about breaking them.
-
94k
-
- Posts: 44
- Joined: Sun Jul 27, 2014 9:41 pm
- Location: Germany
Return to Installation & Troubleshooting
Who is online
Users browsing this forum: No registered users and 2 guests