Gamebuino clone in a mint tin

Général

mick

il y a 6 ans

I tried posting this in the legacy forum (under the Hardware/clone section) but was unable to register. Hopefully it's appropriate to post this here.

I've created a clone that fits inside a mint tin.
I added a 2 pin (female) header so that I can check the battery voltage.


mick

NEW il y a 6 ans

More photos...


DFX2KX

NEW il y a 6 ans

that is awesome.

Sorunome

NEW il y a 6 ans

that is looking pretty neat!

jicehel

NEW il y a 6 ans

Yes great and you could maybe write a mini article to explain how to check the battery voltage on a gamebuino with the spec of the hardware used. I'm near sure that this hack could be fine for some of us as it's should be not too hard to do (even you have to make a hole on your beautifull gamebuino to put the 2 pin (female) header and be able to connect your voltage display.  

mick

il y a 6 ans

The voltage checker was simple to add - it only requires a little soldering.
The header just needs to be attached directly to the battery leads.

I used a usb lipo charger module (TP-4056), so I attached the header to the battery leads where they contact the module (see pic below).

With the header in place, a lipo checker can  then be used - with the help of a couple of jumper leads. These lipo checkers are common amongst RC enthusiasts. There are many types - some just have an alarm, I've used one with a LED display.

The one pictured is one of these:
https://hobbyking.com/en_us/hobbykingtm-lipo-voltage-checker-2s-8s.html

Hopefully that explains it well enough...?

PanStyle

NEW il y a 6 ans

Inspired from the Raspberry Altoids tin console i guess ? : 

https://www.theverge.com/circuitbreaker/2017/4/10/15248838/altoids-tin-raspberry-pi-emulator-sudomod-hack-mints

The battery voltage check is a good idea.

mick

NEW il y a 6 ans

jicehel jicehel

The voltage checker was simple to add - it only requires a little soldering.
The header just needs to be attached directly to the battery leads.

I used a usb lipo charger module (TP-4056), so I attached the header to the battery leads where they contact the module (see pic below).

With the header in place, a lipo checker can  then be used - with the help of a couple of jumper leads. These lipo checkers are common amongst RC enthusiasts. There are many types - some just have an alarm, I've used one with a LED display.

The one pictured is one of these:
https://hobbyking.com/en_us/hobbykingtm-lipo-voltage-checker-2s-8s.html

Hopefully that explains it well enough...?

jicehel

NEW il y a 6 ans

Yes, tank you. Its really easy  ;) 

Aurélien Rodot

NEW il y a 6 ans

Hey, it's awesome! You should definitely make a Creation and tag it as "Hackbuino", "Cases" and "Classic" :)